FS 240, FS 240 C, FS 240 R, FS 240 RC, FS 260 R, FS 260 RC
English
16
N Attach the throttle cable (14) to the
retainer (15).
Swiveling the handlebar
Transport position
N Loosen the wing screw (3) and
unscrew it until the handlebar (7)
can be rotated.
N Rotate the handlebar 90°
counterclockwise and then swing
the handles down.
N Tighten down the wing screw (3)
firmly.
Working position
N Reverse the sequence described
above to swing the handles up and
turn the handlebar clockwise.
Using the Barrier Bar
A barrier bar may have to be mounted to
suit the tool you intend to use – see
"Approved Combinations of Cutting
Attachment, Deflector, Handle and
Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
To Next Page
Loading...
