FS 260 C, FS 360 C
English
26
Fitting the full harness is described in
detail in the instruction sheet supplied.
The type and style of the harness
depend on the market.
FS 260
Putting on the harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
Attaching machine to harness
N Attach the carabiner (1) to the
carrying ring (2) on the shaft.
N Balance the machine – see
"Balancing the Machine".
Disconnecting machine from harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
FS 360
Putting on the harness
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Attach the spring hook to the
machine's perforated rail (3).
N Find the right attachment point for
the cutting attachment you are
using – see "Balancing the
Machine".
Fitting the Full Harness
To Next Page
Loading...
Need help?
General
