FS 260 C, FS 360 C
English
34
Filter Element for Winter Operation
Maintenance and care of the special
filter element for winter operation are
described in the chapter on "Winter
Operation".
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
The carburetor has been set at the
factory to provide an optimum fuel-air
mixture under most operating
conditions.
Adjusting idle speed
Engine stops while idling
N Turn the idle speed screw (LA)
slowly clockwise until the engine
runs smoothly.
Cutting tool rotates when engine is idling
N Turn the idle speed screw (LA)
slowly counterclockwise until the
cutting attachment stops moving.
Engine Management Adjusting the Carburetor
To Next Page
Loading...
