FS 260 C, FS 360 C
English
42
Spark arrestor in muffler and spacer
N If the engine is down on power,
have the spark arrestor in the
muffler checked.
N Check spacer (2) for damage.
N Have damaged spacer (2) replaced
immediately.
Antivibration elements
FS 260 C
A vibration-absorbing rubber element is
installed between the powerhead and
the drive tube. Have it checked if there
are signs of wear or a noticeable
increase in vibration levels.
FS 360 C
Four antivibration elements (arrows) are
installed between the powerhead and
the drive tube. Have the system checked
if there is a noticeable increase in
vibrations.
Both vibration gaps (arrows) are preset
to the same width at the factory. If the
size of the two vibration gaps varies
greatly and/or one of them closes up,
have your servicing dealer repair the
antivibration system.
Wear guard on FS 360 C antivibration
housing
There is an easily replaced wear guard
on the side of the antivibration housing.
The guard may wear as a result of
rubbing against the side plate of the
harness durng operation and should be
replaced if necessary.
To Next Page
Loading...
Need help?
General
