FS 40, FS 40 C, FS 50, FS 50 C
English
30
Assembling the mowing head
N Fit the empty spool in the mowing
head.
If the spring (4) has popped out:
N push it into the spool (2) until it
engages in position with an audible
click.
N Mount the mowing head – see
"Mounting the Mowing Head".
Winding line onto spool
N Use green-coded nylon line with a
diameter of 2.0 mm (0.08 in).
N Cut two 2 m (6ft 6in) lengths of
nylon line from the reel (special
accessory).
N Rotate the spool (2)
counterclockwise until the two arrow
points are in alignment.
N Push the straight end of each line
through one sleeve (5) in the
mowing head (3) until you feel a
noticeable resistance – and then
continue pushing as far as stop.
N Hold the mowing head steady.
N Rotate the spool counterclockwise
until the shortest line is about 10 cm
(4 in).
N If necessary, cut the longer line to a
length of about 10 cm (4 in).
The mowing head is now full.
To Next Page
