FS 40, FS 40 C, FS 50, FS 50 C
English
31
STIHL AutoCut 5-2
Removing remaining nylon line
N Open the mowing head – hold it
steady with one hand and turn the
cap (1) counterclockwise.
N Disengage the spool (2), take it out
of the mowing head and remove the
remaining line.
Winding line onto spool
A prewound spool (special accessory)
may be used as an alternative to the
following procedure.
N Use green-coded nylon line with a
diameter of 2.0 mm (0.08 in).
N Cut two 3 m (9ft 9in) lengths of
nylon line from the reel (special
accessory).
N Insert the ends of each line (3) in the
holes (4) in the spool.
N Bend the ends of the lines over the
edge of the holes to form a hook.
N Straighten out the nylon lines and
wind them tightly on to the spool –
one nylon line in each chamber.
N Engage the ends of the lines in the
notches (2).
Assembling the mowing head
NOTICE
Check that the spring is installed (see
"Mounting the Mowing Head").
To Next Page
Loading...
