FS 400, FS 450
English
24
N Open the filler cap.
N Fill up with fuel.
N Close the filler cap.
WARNING
After fueling, tighten down the filler cap
as securely as possible by hand.
Changing the Fuel Pickup Body
Change the fuel pickup body every year:
N Drain the fuel tank.
N Use a hook to pull the fuel pickup
body out of the tank and take it off
the hose.
N Push the new pickup body into the
hose.
N Place the pickup body in the tank.
N Put on the full harness (1).
N Adjust the length of the strap so that
the spring hook (2) is about a hand’s
width below your right hip. Over-
long ends of straps may be
shortened after completing the
adjustment.
N Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
The unit is balanced differently,
depending on the cutting attachment
used.
N With the unit suspended from the
harness, see how it is balanced and
change attachment point as
necessary:
Mowing attachments
Mowing heads, grass cutting blades and
brush knives and shredder blades
should just touch the ground.
Circular saw blades
Circular saw blades should "hover"
about 20 cm above the ground.
To Next Page
Loading...
Need help?
General
