Stihl FS 450 User Manual

FS 400, FS 450
English
27
N Turn the choke knob to e.
N Select the starting throttle position.
N Start the engine by pulling the
starter rope briskly – 10 to 20 pulls
may be necessary.
If the engine still does not start
N Move the slide control to STOP-0.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Open the throttle wide and hold it
that position.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N Refit the spark plug – see "Spark
Plug".
N Move the slide control to START.
N Set the choke knob to e – even if
the engine is cold.
N Start the engine.
Throttle cable adjustment
N Check adjustment of throttle cable –
see chapter on "Adjusting the
Throttle Cable".
Fuel tank run until completely dry
N After refueling, press the manual
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
N Set the choke knob according to
engine temperature.
N Start the engine.
During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
If there is a noticeable loss of engine
power
N Turn the choke knob to g.
N Loosen the screw (1).
N Remove the filter cover (2).
N Clean away loose dirt from around
the filter and inside the filter cover.
N Remove and check the filter
element (3) – replace if dirty or
damaged.
N Install the filter element in the filter
cover.
N Refit the filter cover.
Operating Instructions Cleaning the Air Filter
1
2
3
256BA074 KN

Stihl FS 450 Specifications

General

Engine Power	2.1 kW
Engine Type	2-stroke
Fuel Tank Volume	0.67 L
Sound Pressure Level	101 dB(A)
Shaft Type	Straight
Displacement	44.3 cm³
Cutting Attachment	Metal blade
Cutting Diameter	480 mm