FSA 65, FSA 85
English
14
N Position your trimmer so that the
mowing head (1) faces up.
The motor housing has guide slots
(arrows) to correctly locate the deflector.
N Push the deflector (2) into the guide
slots as far as stop.
N Insert the screws (3) and tighten
them down firmly.
Adjusting Nylon Line
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 1.2 in. of fresh
line is advanced.
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 1.0 in.
If the line is shorter than 1.0 in:
N Switch off the trimmer.
N Move the retaining latch to ƒ and
remove the battery.
N Turn the trimmer on its back.
N Press down the cap on the spool as
far as stop.
N Pull the ends of the lines out of the
spool.
If the spool is empty, see "Replacing
Nylon Line".
Mains voltage and operating voltage
must be the same.
N Insert the mains plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
Mounting the Deflector
To Next Page
