FSE 60, FSE 71, FSE 81
English
36
N Pull the protective cap off the drive
tube.
N Push the drive tube (1) into the
motor housing (2) as far as the mark
(A), turning the drive tube back and
forth at the same time.
N Tighten down the screw (3) in the
housing firmly.
Mounting the Loop Handle
N Fit the loop handle (1) on the drive
tube at a distance A of about 30 cm
from the control handle (2).
N Insert the hex nut (3) in the loop
handle (1).
N Squeeze the ends of the clamp
together, fit the M6x40 screw (4)
with washer (5) from the other side
and tighten down firmly.
Adjusting Loop Handle to Most
Comfortable Position
N Loosen the screw (4).
N Move the loop handle (1) along the
drive tube to the required position –
tighten down the screw (4) firmly.
Mounting the Drive Tube
To Next Page
Loading...
