Stihl FSE 60 - Page 39

FSE 60, FSE 71, FSE 81
English
37
N Push the deflector (1) over the
clamp (2) as far as stop.
N Fit the locknut (3) in the hex recess
on the deflector.
N Make sure the holes line up.
N Insert the M6x30 screw (4) and
tighten it down firmly.
Preparations
N Switch off the power tool.
N Put your power tool on the ground:
Loop handle pointing down and the
output shaft facing up.
Mounting STIHL AutoCut C 5
-
2 Mowing
Head
N Slip the mowing head (1) over the
shaft (2) and engage hex recess (3)
on the external hexagon (4).
Mounting the Deflector
1
238BA003 KN
2
238BA004 KN
4
3
Mounting the Cutting
Attachment
238BA005 KN
3
2
1
282BA002 KN
4