0478 201 8314 C - EN
22
11.3 Installing the feed chute
● Attach feed chute (1) to the fastening
hooks on basic unit (2) and pivot
forwards.
● Screw in closure screws (3) and
tighten.
11.4 Removing the feed chute
● Unscrew and remove closure
screws (1).
● Pivot feed chute (2) to the rear and
remove.
11.5 Blade set service intervals
Maintenance interval:
Before each use
Check the blade set (consisting of blade
disc, shredding blades, retaining washer,
clamping ring and screw) for wear, firm
seating, cracks or other damage.
11.6 Removing the blade set
1 Lock the blade disc
● Remove the feed chute. (Ö 11.4)
● Turn blade disc (1) to the position
shown and fold locking device (2)
upwards as far as it goes.
Risk of injury!
Always wear thick
gloves.
Before installing the feed
chute, make sure that the cutting
unit is not locked by the locking
device.
Following assembly, check by
visual inspection that the feed chute
is correctly engaged in the
fastening hooks.
Risk of injury!
Always disconnect the mains plug
before removing the closure
screws. Always wear thick gloves.
Risk of injury!
Always wear gloves!
Do not touch the blades
until they have come to a
standstill.
To Next Page
Loading...
