Stihl HL 75 - Page 28

27HL 75, HL 75 K
English / USA
: Pull the rope through the rotor and
secure it with a simple overhand
knot.
: Coat rope rotor bearing bore with
non-resinous oil – see “Special
Accessories“.
: Slide rotor onto starter post –
turn it back and forth until the rewind
spring anchor loop (8) engages.
: Insert screw and tighten down
securely.
: Go to "Tensioning the rewind
spring".
Replacing a broken rewind spring
: Lubricate the new spring with a few
drops of non-resinous oil – see
“Special Accessories“–, do not open
the wire retainer
: Remove the rope rotor.
: Remove parts of old spring.
: Fit the new spring –
position outer spring loop in the
recess – the wire retainer slips off in
this process.
If the spring has popped out:
Refit it in the counterclockwise
direction –
starting outside and working inward.
: Install the rope rotor.
: Check dimension "a" on inner
spring loop and bend it to size if
necessary.
: Go to "Tensioning the rewind
spring".
392BA024 KN
8
392BA025 KN
355BA022 KN
a = 2mm
(0.08in)