Stihl HL 75 - Replacing the Starter Rope and Rewind Spring

26
English / USA
HL 75, HL 75 K
: Take out the screws (1).
: Remove the cable lug (if fitted).
: Lift the starter cover (2) away from
the tank (3) and pull it out from
under the shroud (4).
: Take out the screw (5).
: Remove the rope rotor very
carefully – the rewind spring is
seated in the rope rotor and may
pop out and uncoil if care is not
taken.
: Use a screwdriver to ease the cap
(6) out of the starter grip.
: Remove remaining rope from the
rotor and grip, making sure the
ElastoStart sleeve is not pushed out
of the grip.
: Tie a simple overhand knot in the
end of the new starter rope – see
"Specifications" – and then thread
the rope through the top of the grip
and the rope bush (7).
: Refit the cap in the grip.
Replacing the Starter Rope
and Rewind Spring
386BA004 KN
1
1
1
2
3
4
5
392BA014 KN
6
7
392BA015 KN