Stihl HT 105 Instruction Manual

HT 105, HT 134, HT 135
English
32
Maintenance and Care
The following intervals apply for normal operating conditions. The specified intervals
must be shortened accordingly when working for longer than normal or under difficult
cutting conditions (extensive dust, etc.).
Before starting work At the end of work and/or daily Whenever tank is refilled Weekly Monthly Annually If faulty If damaged As required
Complete machine
Visual inspection (condition, leaks) XX
Clean X
Control handle Function test XX
Air filter
Clean XX
Replace
2)
X
Manual fuel pump (if present)
check X
Have repaired by a specialist dealer
1)
X
Fuel pickup body in fuel tank
Have checked by dealer
1)
X
Have replaced by servicing dealer
1)
XXX
Fuel tank Clean XX
Carburetor
Check idle adjustment – chain must not
rotate
XX
Adjust idle speed X
Spark plug
Adjust electrode gap X
Replace after every 100 hours of
operation
Cooling air intakes
Visual inspection X
Clean X
Valve clearance
1)
If power is low or cranking effort very
high, have valve clearance checked
and, if necessary, adjusted by dealer
1)
X
Spark arresting screen in muffler
Check if installed X
Check or replace
1)
X
All accessible screws, nuts and bolts (not
adjusting screws)
Tighten X

Stihl HT 105 Specifications

General

Power Output	1.05 kW
Guide Bar Length	30 cm
Power Source	Gasoline
Chain Gauge	1.3 mm
Engine Displacement	31.4 cc
Shaft Length	270 cm