EasyManua.ls Logo

Stihl HT 131 - 6.2 Carburetor Servicing; 6.2.1 Carburetor Leakage Test

Stihl HT 131
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HT 100, HT 101, HT 130, HT 131
English
18
N Shut off the engine
N Wear work gloves to protect your
hands.
N The chain must fit snugly against
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand.
N If necessary, retension the chain.
A new chain has to be retensioned more
often than one that has been in use for
some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
N Adjust the throttle cable only when
the unit is completely and properly
assembled.
N Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
The STIHL 4-MIX engine features
mixture lubrication and must be run on a
fuel mixture of gasoline and engine oil.
It operates otherwise on the 4-stroke
principle.
Checking Chain Tension
390BA046 KN
Adjusting the Throttle Cable
002BA163 KN
2
1
002BA161 KN
4-MIX Engine

Table of Contents

Other manuals for Stihl HT 131

Related product manuals