KA 85 R
English
46
N Thread the rope through the rotor
and secure it with a simple
overhand knot.
N Go to "Installing the Rope Rotor".
Replacing a Broken Rewind Spring
Two types of replacement springs are
available from the factory:
– A ready-to-fit rewind spring secured
with a wire retainer.
– A rope rotor with pre-installed
rewind spring.
Installing the ready-to-fit rewind spring
N Lubricate the spring with a few
drops of resin-free oil – see "Special
Accessories" – do not open the wire
retainer!
N Carefully remove the parts of the old
spring from the starter cover and
rope rotor.
N Insert the new rewind spring in the
rope rotor and, at the same time,
engage the outer spring loop in the
rotor’s recess – the wire retainer
slips off in this process. If the spring
pops out and uncoils, refit it in the
counterclockwise direction, starting
outside and working inwards.
N Go to "Installing the Rope Rotor".
Installing rope rotor with rewind spring
N Carefully unpack the new rope rotor
with rewind spring. The spring may
pop out if not handled with care –risk
of injury.
N Lubricate the spring with a few
drops of resin-free oil – see "Special
Accessories".
N Go to "Installing the Rope Rotor".
Installing the Rope Rotor
N Check dimension "a" for inner
spring anchor loop and bend it
slightly if necessary.
N Coat rope rotor bearing bore with
resin-free oil – see "Special
Accessories".
N Slip the rotor over the starter post –
turn it back and forth to engage the
anchor loop (8) of the rewind spring.
N Insert the screw (5) and tighten it
down firmly.
N Go to "Tensioning the Rewind
Spring".
Tension the rewind spring.
N Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions
counterclockwise.
N Hold the rotor steady. Pull out and
straighten the twisted rope.
N Release the rope rotor.
N Release the rope slowly so that it
winds onto the rotor.
N Check spring tension:
To Next Page
Loading...
