KA 85 R
English
47
– The starter grip must be firmly
seated in the rope bushing. If the
grip droops to one side: Add one
more turn on rope rotor to increase
spring tension
– When the starter rope is fully
extended it must still be possible to
rotate the rotor another half turn. If
this is not the case, the spring is
overtensioned and could break.
Take one turn of the rope off the
rotor.
N Go to "Fitting the Starter Cover".
Fitting the Starter Cover
N Push the upper mounting boss of
the cover (2) under the shroud (4).
N Line up the tank and push the
bottom of the cover onto the tank.
N Insert the screws (1) and tighten
them down firmly.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Remove, clean and inspect the
attachment.
N Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
To Next Page
Loading...
