MS 201, MS 201 C
English
24
Version with Easy2Start
N With the right hand, pull the starter
grip slowly and smoothly –
simultaneously press down on the
handlebar – do not pull the starter
rope out all the way – risk of
breakage!
N Do not let the starter grip snap back
– guide it vertically back into the
housing so that the starter rope can
rewind properly
Starting the chain saw
There must not be anyone within the
swivel range of the chain saw.
Version with Easy2Start
N Press the fuel pump bulb at least
five times – even if it is still full of fuel
For all versions
N Push the hand guard (1) forwards –
the chain is blocked
N Simultaneously press the throttle
trigger lockout (2) and throttle
trigger (3) – set master control
lever (4)
Position cold start l
– If engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
N Hold and start the chain saw
When the engine has turned over for the
first time
N Move the Master Control lever (1) to
the position warm start n
N Hold and start the chain saw
Once the engine is running
N Press the throttle trigger lockout and
blip the throttle trigger (2); the
master control lever (1) jumps to
run F and the engine begins to idle
To Next Page
Loading...
Need help?
General
