Stihl MS 210 C User Manual

MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
40
Versions with decompression valve
N Press in the button to open the
decompression valve.
The decompression valve closes as
soon as the engine fires.
N For this reason you must press in
the button before each starting
attempt.
All models
N Push the hand guard (1) forward –
the chain is locked.
N Press down trigger lockout (2) and
pull the throttle trigger at the same
time. Set Master Control lever (3) to:
Choke closed (l)
– If the engine is cold (also use this
position if the engine stopped when
you opened the throttle after
starting)
Starting throttle position (n)
– If the engine is warm, i.e. if it has
been running for about one minute.
N Hold and start your saw as
described.
When the engine begins to fire:
N Set the Master Control lever to the
starting throttle position (n ).
N Hold and start your saw as
described.
As soon as the engine runs
N Press down the trigger lockout and
the blip the throttle trigger (4) – the
Master Control lever (3) moves to
the run position F and the engine
settles down to idling speed.
NOTICE
As the chain brake is still engaged, the
engine must be returned to idling speed
immediately – or the engine housing and
chain brake might otherwise be
damaged.
135BA015 KN
2
1
208BA000 KN
0
3
3
4
5
0
208BA001 KN

Stihl MS 210 C Specifications

General

Displacement	35.2 cm³
Weight	4.6 kg
Weight (without cutting equipment)	4.6 kg
Chain pitch	3/8" P
Guide Bar Length	35-40 cm
Bar length (recommended)	35-40 cm