Stihl MS 210 - Installing the Rope Rotor; Standard rewind starter; Machines with ErgoStart; Tensioning the Rewind Spring

50
English
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
Replacing the Starter Rope
Machines with ElastoStart
1)
: Ease the cap (10) out of the starter
grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
starter grip and tie a simple
overhand knot. Dimension "a"
should be 4 – 7 mm.
: Pull the knot back into the grip.
: Refit the cap in the grip.
1) Special option
: Thread the rope through the top of
the guide bush (11), pull it through
the rotor (12) and secure it with a
simple overhand knot.
: Go to "Installing the Rope Rotor".
Machines without ElastoStart or
machines with ErgoStart
: Remove remaining rope from the
rotor and starter grip.
: Thread the new starter rope through
the rotor and secure it with a simple
overhand knot.
: Thread the other end of the rope
through the rope guide bushing
(from inside) and the underside of
the starter grip and secure it with
one of the special knots shown – do
not wind the rope onto the rotor.
10
208BA014 KN
a
135BA036 KN
1
2
11
108BA015 KN
135BA032 LÄ