Stihl MS 230 Service Manual

7MS 210, MS 230, MS 250
Use the following procedure to fit a DG screw in an existing thread:
– Place the DG screw in the hole and rotate it counterclockwise until drops down slightly.
– Tighten the screw clockwise to the specified torque.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread,
which would weaken the assembly.
Note:
Power screwdriver speed setting for polymer:
– DG screws max. 500 rpm

Stihl MS 230 Specifications

General

Engine Power	2.0 kW
Displacement	40.2 cc
Weight	4.6 kg
Power Output	2.0 kW
Chain Pitch	3/8"
Powerhead Weight	4.6 kg
Bar Length	40 cm
Oil Capacity	200 cc
Bar Lengths Available	35 cm (14") / 40 cm (16")