MSE 170 C, MSE 190 C, MSE 210 C, MSE 230 C
English
17
The backcut must be continued on the
opposite side of the trunk.
Ensure that the second cut is at the
same level as the first cut.
N Engage the bumper spike behind
the hinge and use this as the
rotation point – reposition the
machine as little as possible
N Tip of the guide bar must penetrate
the wood before the holding wood
(4) – guide machine absolutely
horizontally and swivel as widely as
possible
N Make the backcut up to the
hinge (5)
– Do not cut into the hinge
N Make the backcut up to the holding
wood (6)
– Do not cut into the holding wood
Immediately before felling the tree, give
out a second warning cry of "timber!".
N Cut through the holding wood at an
angle from above with arms fully
extended
Remove the machine from the box and
check that you have all the following
items:
– Electric chainsaw
– Guide bar
– Saw chain
– Chain scabbard
– Instruction manual
Only models without quick chain
tensioner
– Combination wrench
To Next Page
Loading...
