EasyManua.ls Logo

Stihl RE 150 PLUS - Pressure Washer STIHL RE 170 PLUS; Extension Cords

Stihl RE 150 PLUS
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0458-663-0121-A
33
English
19 Specifications
19.2 Pressure washer STIHL RE 170 PLUS
Version 230 V / 50 Hz
Fuse (characteristic "C" or "K"): 16 A
Power consumption: 3.3 kW
Maximum permissible mains impedance: 0.45 Ohm
Electrical protection class: I
Degree of electrical protection: IPX5 (protection from
water jets in any direction)
Working pressure (p): 15 MPa (150 bar)
Max. permissible pressure (p max.): 18 MPa (180 bar)
Max. water supply pressure (p in max.): 1 MPa (10 bar)
Maximum water throughput (Q max): 10.8 l/min (648 l/h)
Minimum water throughput (Q min): 9.5 l/min (570 l/h)
Maximum recoil force: 24 N
Max. suction lift: 0.5 m
Max. water temperature in pressure mode (t in max):
60 °C
Max. water temperature in suction mode: 20 °C
Dimensions
Length: 383 mm
Width: 380 mm
Maximum height: 981 mm
Minimum height: 792 mm
Length of high-pressure hose: 12 m
Weight (m) with accessory attached: 31 kg
Version 220-240 V / 50 Hz
Fuse (characteristic "C" or "K"): 10 A
Power consumption: 2.2 kW
Maximum permissible mains impedance: 0.45 Ohm
Electrical protection class: I
Degree of electrical protection: IPX5 (protection from
water jets in any direction)
Working pressure (p): 12 MPa (120 bar)
Max. permissible pressure (p max.): 18 MPa (180 bar)
Max. water supply pressure (p in max.): 1 MPa (10 bar)
Maximum water throughput (Q max): 8.7 l/min (522 l/h)
Minimum water throughput (Q min): 7.8 l/min (468 l/h)
Maximum recoil force: 16 N
Max. suction lift: 0.5 m
Max. water temperature in pressure mode (t in max):
60 °C
Max. water temperature in suction mode: 20 °C
Dimensions
Length: 383 mm
Width: 380 mm
Maximum height: 981 mm
Minimum height: 792 mm
Length of high-pressure hose: 12 m
Weight (m) with accessory attached: 31 kg
19.3 Extension Cords
If an extension cord is used, the cross sectional area of its
conductors must meet the following minimum requirements
– depending on the line voltage and length of the extension
cord:
220 V to 240 V
Cord length up to 20 m: AWG 15 / 1.5 mm²
Cord length 20 m up to 50 m: AWG 13 / 2.5 mm²
100 V to 127 V
Cord length up to 10 m: AWG 14 / 2.0 mm²
Cord length 10 m up to 30 m: AWG 12 / 3.5 mm²

Table of Contents

Related product manuals