Why does my Stihl Pressure Washer switch off while in operation?
Your Stihl pressure washer might be switching off during operation due to a disconnected power supply cord. Ensure the power supply cord is properly connected to an electrical outlet. Another reason may be that the electric motor is too warm; allow the pressure washer to cool at ambient temperatures for about 5 minutes. The nozzle may also be blocked and needs cleaning.
How to fix a Stihl Pressure Washer that won't start even when the spray gun trigger is pulled?
If your Stihl pressure washer doesn't start when you pull the spray gun trigger, check if the power supply cord is correctly connected to a properly installed electrical outlet. Also, the electric motor may be too warm; allow the pressure washer to cool at ambient temperatures for approximately 5 minutes. If it still doesn't work, the nozzle may need cleaning.
Why won't my Stihl RE 110 start when I squeeze the trigger?
If your Stihl Pressure Washer does not start even when you squeeze the spray gun trigger, there are several possible reasons. First, check if the mains plug of the connecting cord or extension cord is properly plugged in. Another reason may be that the circuit breaker or overload cutout has tripped due to an electrical overload or fault. In that case, identify and fix the cause of the tripping, then reset the breaker or cutout, and switch off other devices connected to the same circuit. Also, ensure that the socket has the correct fuse rating. If using an extension cord, make sure it has an adequate cross-section and is not too long. Finally, the electric motor may be too warm; allow the pressure washer to cool for 5 minutes and clean the nozzle.
What to do if my Stihl RE 110 does not start when switched on but the electric motor hums?
If your Stihl pressure washer doesn't start when switched on and the electric motor hums, the mains voltage may be too low. Try pulling and holding the spray gun trigger while switching on the pressure washer. Also, try switching off other loads connected to the same electrical circuit.
Why is detergent not being drawn in my Stihl RE 110?
If detergent is not being drawn into your Stihl pressure washer, first check if the detergent container is empty and fill it with detergent. If the container is full, the nozzle of the detergent spray set may be blocked, so clean the nozzle of the detergent spray set.
How to fix stiff connections on my Stihl Pressure Washer?
If the connections of your Stihl pressure washer, high-pressure hose, spray gun, or spray lance are stiff, the gaskets of the connections may not have been greased. Grease the gaskets to resolve this issue.
What to do if my Stihl RE 110 Pressure Washer switches off while in use?
If your Stihl Pressure Washer switches off during operation, there are a couple of things you should check. First, make sure that the plug of the connecting cord or extension cord hasn't been pulled out of the socket. If it has, plug it back in. Secondly, the circuit breaker or overload cutout might have tripped due to an electrical overload or a fault in the circuit. Find the cause of the tripping, fix it, and then reset the circuit breaker or overload cutout. You might also want to switch off other appliances connected to the same circuit.
Why is my Stihl RE 110 Pressure Washer not drawing detergent?
If the detergent additive is not being drawn in by your Stihl Pressure Washer, the first thing to check is whether the container is empty. If so, fill it with detergent. Also, the nozzle of the spraying set may be blocked, so try cleaning it.
What to do if the water pressure fluctuates or drops in my Stihl Pressure Washer?
If the water pressure in your Stihl pressure washer fluctuates or drops, it could be due to several reasons. First, ensure that the water tap is fully open to provide enough water. Make sure that a sufficient quantity of water is available. The nozzle could be blocked and needs cleaning. Also, the water intake screen or water filter might be blocked and require cleaning. If none of these steps work, the high-pressure pump, high-pressure hose, or spray attachment may be leaking or faulty, and you should ask a STIHL servicing dealer to inspect the pressure washer.
Why is my Stihl RE 110 Pressure Washer high-pressure pump repeatedly switching on and off?
If the high-pressure pump on your Stihl pressure washer repeatedly switches on and off without pulling the spray gun trigger, there may be a leak in the high-pressure pump, high-pressure hose, or spray attachment. Have the pressure washer inspected and repaired by an authorized STIHL servicing dealer.
Provides essential general safety precautions for operating electric pressure washers.
Specifies necessary PPE like eye protection, gloves, and footwear for safe operation.
Covers safety procedures and considerations for the actual operation of the pressure washer.
Explains safety signal words used in the manual for hazard communication.
Identifies and describes the main components of the pressure washer unit.
Illustrates and explains safety symbols found on the pressure washer itself.
Defines the specific applications and intended use of the pressure washer.
Details safety precautions regarding the power supply cord and plug.
Lists steps and safety checks to perform before starting to use the pressure washer.
Provides instructions on how to hold and control the pressure washer safely during operation.
Presents a chart detailing inspection and maintenance intervals for the machine.
Lists essential steps for preparing the pressure washer before each use.
Provides instructions for assembling the main parts and accessories of the pressure washer.
Explains how to connect and disconnect the high-pressure hose.
Guides on how to safely connect the pressure washer to the main water supply.
Explains the procedure for safely turning the pressure washer on.
Details how to operate and secure the spray gun trigger during use.
Outlines the steps to prepare the pressure washer for transport or storage.
Provides instructions on protecting the pressure washer from freezing temperatures.
Provides instructions on how to safely transport the pressure washer.
Details how to clean the high-pressure nozzle and spray lance if clogged.
Guides on how to clean the water intake screen to ensure proper water flow.
Lists common problems and their solutions for the pressure washer.
Provides technical specifications for the STIHL RE 110 model.
Recommends using genuine STIHL replacement parts for maintenance and repair.
Advises on the environmentally friendly disposal of the pressure washer.
General| Form factor | Upright |
|---|---|
| Hose length | 7 m |
| Cable length | 5 m |
| Power source | Electric |
| Product color | Black, Orange |
| Pump material | Aluminum |
| Detergent tank | - |
| Maximum flow rate | 440 l/h |
| Minimum flow rate | 380 l/h |
| Sound power level | 81 dB |
| Vibration emission | 1.8 m/s² |
| Working pressure (max) | 120 bar |
| Working pressure (min) | 110 bar |
| Maximum water temperature | 40 °C |
| AC input voltage | 230 V |
| Power consumption (typical) | - W |
Weight and Dimensions| Weight | 17600 g |
|---|
To Next Page
