EasyManua.ls Logo

Stihl RE 100 PLUS CONTROL - User Manual

Stihl RE 100 PLUS CONTROL
84 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
STIHL RE 100 PLUS CONTROL
Owners Instruction Manual
Instruction Manual
Manual de instrucciones
WARNING
Read Instruction Manual thoroughly before use and
follow all safety precautions – improper use can cause
serious or fatal injury.
ADVERTENCIA
Antes de usar la máquina lea y siga todas las precauciones
de seguridad dadas en el manual de instrucciones – el uso
incorrecto puede causar lesiones graves o mortales.

Table of Contents

Other manuals for Stihl RE 100 PLUS CONTROL

Preview: Instruction Manual
Instruction Manual36 pages

Questions and Answers

  • V
    Vincent ValdezJul 27, 2025
    Why won't my Stihl Pressure Washer start when I pull the trigger?
    • B
      Brian BowersJul 28, 2025
      If your Stihl Pressure Washer doesn't start even when you pull the spray gun trigger, here's what you can check: * Ensure the power supply cord is properly connected to a working electrical outlet. * If the GFCI (Ground Fault Circuit Interrupter) has tripped, reset it. Try switching off other devices on the same circuit. If it still fails, disconnect the pressure washer and have it inspected by a STIHL servicing dealer. * The motor might be too hot. Let the pressure washer cool down for about 5 minutes and clean the nozzle.
  • J
    jonesjaredAug 1, 2025
    How to troubleshoot a Stihl RE 100 PLUS CONTROL that won't start when trigger is squeezed?
    • H
      henrybarnesAug 1, 2025
      If your Stihl Pressure Washer doesn't start when you squeeze the spray gun trigger, make sure the connecting cable or extension cord is properly plugged in. Check if the circuit-breaker or residual current circuit breaker has tripped due to an electrical overload or fault; if so, identify and fix the cause, then re-engage the breaker. Also, ensure the socket's fuse rating is adequate and that you're using an extension cord with the correct cross-section and length. If the motor is too warm, let the pressure washer cool down for 5 minutes and clean the nozzle.
  • R
    Roger StevensAug 5, 2025
    Why Stihl RE 100 PLUS CONTROL Pressure Washer won't start and electric motor buzzes?
    • J
      Julia GoodwinAug 5, 2025
      If your Stihl Pressure Washer doesn't start when switched on and the motor buzzes, it could be due to low mains voltage. Try squeezing and holding the spray gun trigger while switching on the pressure washer. Also, switch off other devices connected to the same circuit. Ensure that the extension cord has an adequate cross-section and correct length.
  • A
    alan11Aug 9, 2025
    What to do if my Stihl RE 100 PLUS CONTROL keeps turning off?
    • J
      Jo RobertsAug 9, 2025
      If your Stihl Pressure Washer shuts off while you're using it, consider these potential causes: 1. The power supply cord might not be properly connected to the electrical outlet. Ensure it's securely plugged in. 2. The GFCI (Ground Fault Circuit Interrupter) could have interrupted the circuit. Reset the GFCI. If the issue persists, have an authorized STIHL servicing dealer inspect the pressure washer after disconnecting it from the power supply. 3. The electric motor may be overheating. Allow the pressure washer to cool down for about 5 minutes and clean the nozzle.
  • G
    grodriguezAug 14, 2025
    How to fix a Stihl RE 100 PLUS CONTROL that hums but doesn't start?
    • T
      tcarrollAug 14, 2025
      If your Stihl Pressure Washer hums but doesn't start, it could be due to low mains voltage. Try pulling and holding the spray gun trigger while switching on the pressure washer. Also, switch off other devices connected to the same electrical circuit.
  • D
    danielle81Aug 17, 2025
    What to do if Stihl Pressure Washer switches off while in operation?
    • V
      Victor MccarthyAug 18, 2025
      If your Stihl Pressure Washer switches off during operation, ensure that the connecting cord or extension cord is properly plugged into the socket. Also, check if the circuit-breaker or the residual current circuit breaker has tripped, indicating an electrical overload or a fault in the circuit. If it has tripped, identify and remedy the cause before re-engaging the breaker. You may also want to switch off other appliances connected to the same circuit.
  • S
    Sheri RileyAug 22, 2025
    What to do if Stihl Pressure Washer pump cycles on and off by itself?
    • G
      gerald51Aug 22, 2025
      If the high-pressure pump on your Stihl Pressure Washer is cycling on and off without you pulling the trigger, there might be a leak in the high-pressure pump, hose, or spray attachment. It's recommended to have the pressure washer inspected and repaired by an authorized STIHL servicing dealer.

Summary

Main Parts

Pressure Washer

Identifies and describes the main components of the pressure washer unit.

Safety Symbols on the Product

IMPORTANT SAFETY INSTRUCTIONS

General Safety Warnings and Instructions

Provides essential general safety advice and precautions for operating the pressure washer.

Operator

Personal Protective Equipment

Specifies necessary protective gear to be worn during operation.

Pressure Washer

Details safety precautions related to the pressure washer unit itself.

Power Supply Cord

Covers safety guidelines for the power cord and its connection.

Connecting the Water Supply

Explains safe procedures for connecting the pressure washer to the water source.

Using the Pressure Washer

Offers important safety advice for the actual operation of the pressure washer.

Maintenance, Repair and Storage

Warnings and Instructions

Before Starting Work

Preparing the Pressure Washer for Operation

Steps to take and checks to perform before operating the pressure washer.

Assembling the Pressure Washer

Assembling Parts and Accessories

Instructions for assembling the main parts and accessories of the pressure washer.

Connecting the High-Pressure Hose

Spray Gun and Lance

Inserting and Removing the Spray Nozzle

Connecting the Water Supply

Connecting the Pressure Washer to the Mains Water Supply

Explains how to connect the pressure washer to the household water system.

Ground Fault Circuit Interrupter (GFCI)

Testing the GFCI

Instructions on how to test the Ground Fault Circuit Interrupter for safety.

Resetting the GFCI

Switching the Pressure Washer On and Off

Switching On

Guide on how to safely start the pressure washer.

Switching Off

Instructions for safely shutting down the pressure washer.

During Operation

Activating and Locking the Spray Gun Trigger

Setting the Working Pressure

How to adjust the pressure level for different cleaning tasks.

Adding Detergents

After Finishing Work

Preparing for Transportation or Storage

Transporting

Storing

Cleaning

Inspection and Maintenance

Inspection and Maintenance Chart

Troubleshooting Guide

Pressure Washer

Common problems and their solutions for the pressure washer.

Specifications

Stihl RE 100 PLUS CONTROL Specifications

General IconGeneral
Power SupplyElectric
Operating pressure110 bar
Max. water temperature40 °C
Mains voltage230 V
Power cable length5 m
Power SourceElectric
Voltage230 V
Frequency50 Hz

Related product manuals