Stihl RE 100 PLUS CONTROL - Connecting the Water Supply; Connecting the Pressure Washer to the Mains Water Supply

0458-004-8621-A
19
English 8 Assembling the Pressure Washer
► Insert the control panel into the spray gun.
The control panel engages with an audible click.
8.4 Spray Gun and Lance
8.4.1 Connecting the Spray Gun and Lance
To connect the spray gun and lance:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Lock the spray gun trigger.
► Remove all sand and debris from the connections and
couplings.
► Push the high-pressure hose (2) into the spray gun (1).
► If the high-pressure hose is difficult to push into the spray
gun, apply a food-safe fitting grease to the sealing surface
on the high pressure hose.
► Attach the spray lance (1) to the spray gun (2).
► Push the spray lance as far as it will go into the spray gun.
► Once inserted, turn the spray lance clockwise until it
engages.
► If the spray lance is difficult to insert into the spray gun,
apply a food-safe fitting grease to the sealing surface on
spray gun.
8.4.2 Removing the Spray Gun and Lance
WARNING
To reduce the risk of severe injury from high-pressure spray,
always switch off the pressure washer, shut off the water
supply, relieve any remaining pressure in the system and
lock the spray gun trigger before attempting to remove or
disassemble the spray gun or lance.
To remove the spray gun and lance:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
2
1
0000097566_001
0000-GXX-4350-A0
1
2