0458-004-8621-A
18
English
8 Assembling the Pressure Washer
Nozzle
► Insert 3-in-1 nozzle (1).
8.2 Connecting the High-Pressure Hose
WARNING
Before starting assembly, switch off the pressure washer,
disconnect the unit from the power supply and ensure all
pressure is released from the system to reduce the risk of
injury from unintended spraying.
To connect the high-pressure hose:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Remove all sand and debris from the connections and
couplings.
► Push the high-pressure hose (1) into the coupling (2).
► Fit the cover (3) so that it is flush with the housing. Cover
the coupling with the cover.
► Insert screw (4) into the cover and tighten.
► If the high-pressure hose is difficult to push into the
coupling, apply a food-safe fitting grease to the sealing
surface on the high pressure hose.
8.3 Installing the Batteries
► Press the locking button (1).
► Remove control panel (2).
► Open the retaining latch (3).
► Remove the cover (4).
► Insert the batteries (5) into the control panel (2) according
to the polarity- (+/-).
► Close cover (4).
1
0000085775_001
1
2
3
4
0000098487_001
4
2
5
0000098499_001
To Next Page
Loading...
