How to fix the shape of the water jet if it has changed on my Stihl Pressure Washer?
If the shape of the water jet from your Stihl pressure washer has changed, it's likely due to a blocked or worn nozzle. Try cleaning the nozzle first. If that doesn't solve the problem, you may need to fit a new nozzle.
What to do if my Stihl Pressure Washer switches off while in operation?
If your Stihl Pressure Washer switches off during operation, check if the power supply cord is properly connected to an electrical outlet. Also, the electric motor might be too warm. In this case, allow the pressure washer to cool at ambient temperatures for approximately 5 minutes. You may also need to clean the nozzle.
Why won't my Stihl RE 130 PLUS Pressure Washer start when I squeeze the spray gun trigger?
There are several possible reasons why your Stihl pressure washer might not start. First, check that the mains plug of the connecting cable or extension cord is properly plugged in. Another reason could be that the circuit-breaker (fuse) or the residual current circuit breaker has tripped due to an electrical overload or a fault in the circuit. If this is the case, look for the cause of the tripping, remedy it, and then engage the circuit-breaker. Also, ensure that the fuse rating of the socket is adequate and that you are using an extension cord with the correct cross-section and length. Finally, the electric motor may be too warm; allow the pressure washer to cool for 5 minutes and clean the nozzle.
Why is detergent not being drawn in my Stihl Pressure Washer?
If your Stihl Pressure Washer is not drawing in detergent, first check if the detergent container is empty and fill it if necessary. Also, the nozzle of the detergent spray set might be blocked, so clean it.
What to do if my Stihl RE 130 PLUS does not start and the motor hums?
If your Stihl Pressure Washer does not start and the electric motor hums, the mains voltage might be too low. Pull and hold the spray gun trigger and switch on the pressure washer. Also, switch off other loads connected to the same electrical circuit.
Why is my Stihl RE 130 PLUS's high-pressure pump repeatedly switching on and off?
If the high-pressure pump on your Stihl pressure washer repeatedly switches on and off without you squeezing the spray gun trigger, this may indicate a leak in the high-pressure pump, high-pressure hose, or spray attachment. It is recommended to ask a STIHL servicing dealer to inspect the pressure washer.
How to fix stiff connections on Stihl Pressure Washer?
If the connections of your Stihl Pressure Washer's high-pressure hose, spray gun, or spray lance are stiff, the gaskets of the connections may not have been greased. Grease the gaskets.
Why does the pressure working pressure fluctuate or drop on my Stihl RE 130 PLUS?
If the working pressure of your Stihl pressure washer fluctuates or drops, it could be due to several reasons. First, ensure that the water tap is fully open and that there is a sufficient quantity of water available. A blocked nozzle or a blocked water intake screen or water filter can also cause this issue, so clean them accordingly. If these steps don't resolve the problem, the high-pressure pump, high-pressure hose, or spray attachment may be leaking or faulty, and you should have it inspected by a STIHL servicing dealer.
What to do if detergent additive is not being drawn in Stihl RE 130 PLUS Pressure Washer?
If your Stihl pressure washer is not drawing in detergent additive, first check if the container is empty and fill it with detergent. If the container is full, the nozzle of the spraying set may be blocked, so clean it.
What to do if Stihl RE 130 PLUS hums but doesn't start?
If your Stihl pressure washer does not start when switched on and the motor hums, the mains voltage may be too low. Pull and hold the spray gun trigger and switch on the pressure washer. Try switching off other loads connected to the same electrical circuit.
General| Form factor | Upright |
|---|---|
| Hose length | 9 m |
| Cable length | 5 m |
| Power source | Electric |
| Product color | Black, Orange |
| Pump material | Aluminum |
| Detergent tank | - |
| Maximum flow rate | 500 l/h |
| Minimum flow rate | 400 l/h |
| Sound power level | 86 dB |
| Vibration emission | 2.4 m/s² |
| Working pressure (max) | 150 bar |
| Working pressure (min) | 135 bar |
| Maximum water temperature | 40 °C |
| AC input voltage | 230 V |
| Power consumption (typical) | - W |
Weight and Dimensions| Weight | 21200 g |
|---|
Introduces the manual, safety signals, and guidance for using the document.
Details the main parts of the pressure washer and spray attachment.
Explains safety symbols found on the pressure washer for user awareness.
Crucial safety warnings and instructions for operating the pressure washer safely.
Guidelines for operator qualifications, health, and necessary personal protective equipment.
Safety considerations for power cord usage and water supply connections.
Instructions for preparing the unit and assembling its parts before operation.
Procedures for connecting the pressure washer to water sources and hoses.
Steps for switching the pressure washer on, off, and operating it.
Details on unrolling the hose, using the trigger, and adding detergents.
Procedures for cleaning the unit and protecting it from freezing temperatures.
Schedule and tasks for routine inspection, maintenance, and gasket lubrication.
Solutions for common problems encountered with the pressure washer.
Key technical data, symbols, replacement parts, and disposal information.
To Next Page
