What to do if detergent additive is not being drawn in Stihl RE 130 PLUS Pressure Washer?
If your Stihl pressure washer is not drawing in detergent additive, first check if the container is empty and fill it with detergent. If the container is full, the nozzle of the spraying set may be blocked, so clean it.
What to do if my Stihl RE 130 PLUS Pressure Washer does not start even when the spray gun trigger is pulled?
If your Stihl Pressure Washer doesn't start when the spray gun trigger is pulled, there are a couple of things to check. Make sure the power supply cord is properly connected to a functioning electrical outlet. Also, the electric motor might be too warm; if so, allow the pressure washer to cool down at ambient temperatures for about 5 minutes. You may also need to clean the nozzle.
What to do if Stihl RE 130 PLUS hums but doesn't start?
If your Stihl pressure washer does not start when switched on and the motor hums, the mains voltage may be too low. Pull and hold the spray gun trigger and switch on the pressure washer. Try switching off other loads connected to the same electrical circuit.
Why is my Stihl Pressure Washer not picking up detergent?
If your Stihl Pressure Washer isn't drawing in detergent, first check if the detergent bottle is empty and fill it if needed. If the bottle is not empty, the nozzle of the detergent spray set may be blocked; clean it.
What to do if my Stihl Pressure Washer switches off during use?
If your Stihl pressure washer switches off while in operation, make sure the power cord is properly connected to an electrical outlet. Also, the motor may be overheating, so allow the pressure washer to cool at ambient temperatures for about 5 minutes and clean the nozzle.
Why does the water pressure fluctuate on my Stihl RE 130 PLUS Pressure Washer?
If the water pressure of your Stihl Pressure Washer fluctuates or drops, fully open the water tap to ensure a sufficient water supply. Also, check if the nozzle, water intake screen, or water filter is blocked and clean them. If the issue persists, the high-pressure pump, hose, or spray attachment may be leaking; in this case, have the pressure washer inspected by a STIHL servicing dealer.
Why are the connections of my Stihl RE 130 PLUS stiff?
If the connections of your pressure washer, high-pressure hose, spray gun, or spray lance are stiff, it is likely that the gaskets of the connections have not been greased. Grease the gaskets to resolve this issue.
What to do if my Stihl RE 130 PLUS does not start and the motor hums?
If your Stihl Pressure Washer does not start and the electric motor hums, the mains voltage might be too low. Pull and hold the spray gun trigger and switch on the pressure washer. Also, switch off other loads connected to the same electrical circuit.
Why is detergent not being drawn in my Stihl Pressure Washer?
If your Stihl Pressure Washer is not drawing in detergent, first check if the detergent container is empty and fill it if necessary. Also, the nozzle of the detergent spray set might be blocked, so clean it.
Why won't my Stihl RE 130 PLUS Pressure Washer start when I squeeze the spray gun trigger?
There are several possible reasons why your Stihl pressure washer might not start. First, check that the mains plug of the connecting cable or extension cord is properly plugged in. Another reason could be that the circuit-breaker (fuse) or the residual current circuit breaker has tripped due to an electrical overload or a fault in the circuit. If this is the case, look for the cause of the tripping, remedy it, and then engage the circuit-breaker. Also, ensure that the fuse rating of the socket is adequate and that you are using an extension cord with the correct cross-section and length. Finally, the electric motor may be too warm; allow the pressure washer to cool for 5 minutes and clean the nozzle.
Introduces the manual, safety signals, and guidance for using the document.
Details the main parts of the pressure washer and spray attachment.
Explains safety symbols found on the pressure washer for user awareness.
Crucial safety warnings and instructions for operating the pressure washer safely.
Guidelines for operator qualifications, health, and necessary personal protective equipment.
Safety considerations for power cord usage and water supply connections.
Instructions for preparing the unit and assembling its parts before operation.
Procedures for connecting the pressure washer to water sources and hoses.
Steps for switching the pressure washer on, off, and operating it.
Details on unrolling the hose, using the trigger, and adding detergents.
Procedures for cleaning the unit and protecting it from freezing temperatures.
Schedule and tasks for routine inspection, maintenance, and gasket lubrication.
Solutions for common problems encountered with the pressure washer.
Key technical data, symbols, replacement parts, and disposal information.
General| Form factor | Upright |
|---|---|
| Hose length | 9 m |
| Cable length | 5 m |
| Power source | Electric |
| Product color | Black, Orange |
| Pump material | Aluminum |
| Detergent tank | - |
| Maximum flow rate | 500 l/h |
| Minimum flow rate | 400 l/h |
| Sound power level | 86 dB |
| Vibration emission | 2.4 m/s² |
| Working pressure (max) | 150 bar |
| Working pressure (min) | 135 bar |
| Maximum water temperature | 40 °C |
| AC input voltage | 230 V |
| Power consumption (typical) | - W |
Weight and Dimensions| Weight | 21200 g |
|---|
To Next Page
