0458-624-8221-A
23
English
10 Switching the Pressure Washer On and Off
10.1 Switching On
WARNING
Never operate your pressure washer if it is damaged,
improperly adjusted or maintained, not completely and
securely assembled or not functioning properly, @ 5.5. To
reduce the risk of personal injury, always wear proper
clothing and protective apparel, including proper eye
protection, when operating your pressure washer, @ 5.4.
Before switching on:
► Make sure you have a secure and firm footing.
► Stand upright.
► Always hold and operate the pressure washer with one
hand firmly on the spray gun and your other hand firmly on
the spray lance. Always hold the pressure washer with two
hands in this manner.
To switch the pressure washer on:
► Set the switch to the I position.
NOTICE
When the pressure washer is switched on, voltage
fluctuations may occur under unfavorable mains conditions
with a power line impedance greater than 0.15 Ohm. The
voltage fluctuations may negatively affect other connected
electrical appliances.
10.2 Switching Off
To switch the pressure washer off:
► Set the switch to the 0 position.
11.1 Unrolling the High-Pressure Hose
WARNING
Releasing the spray gun trigger causes a kickback in the
high-pressure hose. A kickback causes the high-pressure
hose to expand. If the high-pressure hose is not completely
unrolled from the hose reel, the high-pressure hose has no
room to expand and the high-pressure hose may suffer
damage. Water under high pressure may escape
uncontrolled into the surrounding area. This can result in
serious injuries and damage to property.
10 Switching the Pressure Washer On
and Off
0000-GXX-4357-A0
11 During Operation
0000-GXX-4358-A0
To Next Page
Loading...
Need help?
General
Weight and Dimensions
