0458-004-8621-A
23
English
11 Switching the Pressure Washer On and Off
10.2 Resetting the GFCI
To reset the GFCI:
► If depressing the TEST button has interrupted the current
and the red indicator plate inside the window (2) is no
longer visible, depress the RESET button (3).
The indicator plate should become visible again.
► If the indicator plate is not visible after depressing the
RESET button, the GFCI is not working. Disconnect the
pressure washer from the power supply and have it
inspected by an authorized STIHL servicing dealer before
further use.
11.1 Switching On
WARNING
Never operate your pressure washer if it is damaged,
improperly adjusted or maintained, not completely and
securely assembled or not functioning properly, @ 5.5. To
reduce the risk of personal injury, always wear proper
clothing and protective apparel, including proper eye
protection, when operating your pressure washer, @ 5.4.
Before switching on:
► Make sure you have a secure and firm footing.
► Stand upright.
► Always hold and operate the pressure washer with one
hand firmly on the spray gun and your other hand firmly on
the spray lance. Always hold the pressure washer with two
hands in this manner.
To switch the pressure washer on:
► Set the switch to the I position.
11.2 Switching Off
To switch the pressure washer off:
► Set the switch to the 0 position.
11 Switching the Pressure Washer On
and Off
2
1
3
0000-GXX-B524-A0
0000-GXX-5305-A00000-GXX-5306-A0
To Next Page
Loading...
Need help?
General
