Stihl RE 110 User Manual

0458-620-8221-A
16
English 7 Before Starting Work
washerinspecting it or carrying out any cleaning,
maintenance or repair work, before storing, and any
other time it is not in use.
￭ This electric pressure washer is double-insulated. In such
an appliance, two systems of insulation are provided as
protection against electric shock. No grounding means are
provided, nor should means for grounding be added to the
appliance. Servicing a double-insulated appliance
requires extreme care and knowledge of the system, and
should be done only by qualified service personnel.
￭ Use of parts that are not authorized or approved by STIHL
may cause serious or fatal injury or property damage.
– STIHL recommends that only identical authorized
STIHL replacement parts be used for repair or
maintenance.
– If using a replacement or accessory high-pressure
hose, ensure that it is rated for the maximum PSI of
the pressure washer.
– If using a replacement spray gun or lance, or any
other spray accessory, ensure that it is rated for the
maximum PSI of the pressure washer.
￭ To reduce the risk of electric shock:
– Ensure that the insulation of the power supply cord
and plug are in good condition and show no signs of
aging (brittleness), wear or damage.
– Never use your pressure washer if the casing around
the motor is cracked or damaged.
￭ Improper storage can result in unauthorized use, damage
to the pressure washer and an increased risk of fire,
electric shock and other personal injury or property
damage.
– Disconnect the pressure washer from the power
supply before storing.
– Never store the pressure washer with the plug of the
power supply cord connected to an electrical outlet.
– Store the pressure washer indoors in a dry, secure
place that cannot be accessed by children or other
unauthorized users.
NOTICE
SAVE THESE
INSTRUCTIONS!
7.1 Preparing the Pressure Washer for Operation
Before starting work:
► Clean the water filter, if necessary, @ 15.4.
► Place the pressure washer on flat and firm ground or other
solid surface in an open area.
► Connect the high-pressure hose, @ 8.3.1.
► Connect the spray gun and lance, @ 8.4.1.
► Insert the spray nozzle, @ 8.5.1.
► If desired, add detergent, @ 11.2.
► Connect the water supply, @ 9.
► Connect the power supply cord to a properly installed
electrical outlet that matches the voltage and electrical
frequency stated on the pressure washer's rating plate.
– Drain the detergent spray set or secure it
so that it cannot topple over and cannot
move.
– Do not allow the unit to be used or stored
in freezing temperatures.
– If the pressure washer must be
transported or stored in freezing
conditions, the pump must be filled with
antifreeze to prevent cracking due to
water expansion, @ 12.2.
7 Before Starting Work

Stihl RE 110 Specifications

General

Form factor	Upright
Hose length	7 m
Cable length	5 m
Power source	Electric
Product color	Black, Orange
Pump material	Aluminum
Detergent tank	-
Maximum flow rate	440 l/h
Minimum flow rate	380 l/h
Sound power level	81 dB
Vibration emission	1.8 m/s²
Working pressure (max)	120 bar
Working pressure (min)	110 bar
Maximum water temperature	40 °C
AC input voltage	230 V
Power consumption (typical)	- W

Weight and Dimensions

Weight	17600 g