Stihl RMI 422 - Page 180

0478 131 9963 F - EN
178
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return robotic mower to mowing area
and dock to charge battery (Ö 15.6)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
– Repeat edge following (Ö 11.13)
– Contact a STIHL specialist dealer for a
detailed diagnosis
Message:
2071 – GPS signal
No reception at starting pt. 1
Possible cause:
– Starting point 1 is in a dead spot
Remedy:
– Change the position of starting point 1
(Ö 11.14)
Message:
2072 – GPS signal
No reception at starting pt. 2
Possible cause:
– Starting point 2 is in a dead spot
Remedy:
– Change the position of starting point 2
(Ö 11.14)
Message:
2073 – GPS signal
No reception at starting pt. 3
Possible cause:
– Starting point 3 is in a dead spot
Remedy:
– Change the position of starting point 3
(Ö 11.14)
Message:
2074 – GPS signal
No reception at starting pt. 4
Possible cause:
– Starting point 4 is in a dead spot
Remedy:
– Change the position of starting point 4
(Ö 11.14)
Message:
2075 – GPS signal
No reception in desired zone
Possible cause:
– The desired zone is in a dead spot
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2076 – GPS signal
Desired zone not found
Possible cause:
– The desired zone could not be found
during edge following
Remedy:
– Redefine the desired zone. Make sure
that the desired zone and perimeter
wire overlap (Ö 10.)
Message:
2077 – Desired zone
Desired zone outside home area
Possible cause:
– The desired zone is outside the stored
home area
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2090 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the radio module
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
2100 – GPS protect.
Outside home area
Machine disabled
Possible cause:
– Robotic mower was removed from
home area
Remedy:
– Return robotic mower to home area and
enter PIN code (Ö 5.9)