ENNO
25
SVFIDAPL
0478 192 9810 A - EN
Pour in the fuel slowly and carefully. In
order to prevent the fuel from overflowing,
filling should be performed in several
stages.
Remove the funnel between the individual
filling operations in order to visually check
the filling level in the tank.
The more fuel has already been filled into
the tank, the smaller the filling quantities
should be for each filling operation. To give
the fuel room to expand, never fill the fuel
tank past the lower edge of the filler neck.
Tank cap:
Unscrew the tank cap (1) (note direction of
arrow) and remove.
● Fill the fuel into the tank using a suitable
funnel (not included in standard
equipment) (see Filling procedure).
Fit and screw on the tank cap (1) (note
direction of arrow). Then tighten the tank
cap (1) hand-tight.
● Wipe away any spilled fuel and allow it
to evaporate before starting the engine.
12.2 Starting the engine
The following points must be noted
before starting:
● Carefully read and observe the section
entitled "For your safety". (Ö 4.)
● Check the engine oil level. (Ö 14.12)
● Remove grass residues from the
mowing deck and engine compartment.
● Check the fuel.
● Before each use, check the braking
function. (Ö 12.5)
● Perform all personal settings (driver's
seat adjustment) on the machine.
Not when the engine is running!
● Never start the machine in the vicinity of
other persons, particularly children, or
animals.
Starting sequence
Start the machine in the following
sequence.
● Open the fuel cock. (Ö 14.8)
● Before starting, press the brake pedal
to the stop and hold or engage the
parking brake. (Ö 8.11), (Ö 8.12)
● Check the mowing deck switch:
The mowing deck must be disengaged.
(Ö 8.5)
● Insert the ignition key in the ignition lock
and turn to the "ignition on/engine
running" position. (Ö 8.1)
To prevent fuel spillage, use a
suitable funnel (not included in
standard equipment) when filling
up.
Risk of injury:
Before starting, carefully read and
observe the section "For your
safety". (Ö 4.)
Only start the machine when the
user is sitting on the driver's seat.
When operating (e.g. mowing), the
throttle lever should always be in
the MAX position.
Avoid damage to the machine.
If the engine fails to start, it must be
noted that the engine can flood
following several starting attempts.
When attempting to start, the
ignition key should never be held in
the "start engine" position for more
than a maximum of 10 seconds.
To Next Page
Loading...
