ENNO
29
SVFIDAPL
0478 192 9810 A - EN
Loosen the screw (8) behind the right front
wheel (9).
Press the retaining plate (7) forwards and
hold in place. Fold the V-belt cover (6)
downwards. The V-belt cover rests against
the V-belt.
Detaching the V-belt:
Press the retaining plate (7) forwards and
hold in place. Pull the V-belt (10) forwards
and detach.
Detaching the mowing deck at the rear:
● Select the lowest cutting level. (Ö 8.13)
Remove the cotter pin (5).
Lift the mowing deck (1) slightly and hold.
Detach the mowing deck (1) from the rear
mowing deck mounting (4).
● Repeat this procedure on the other
side.
● Carefully and slowly set down the
mowing deck.
● Carefully set the cutting height
adjustment lever to the highest cutting
level.
Detaching the mowing deck at the
front:
Danger of pinching:
Before pulling out the cotter pin,
ensure that no body parts (hands,
fingers, feet, etc.) are positioned
directly under the mowing deck.
Risk of injury:
The cutting height adjustment lever
is under tension when the mowing
deck is detached at the rear.
Carefully set the cutting height
adjustment lever to the highest
cutting level immediately after
detaching the mowing deck.
Note
To facilitate removal, note and
carefully observe the specified
sequence.
Danger of pinching:
Before detaching, ensure that no
body parts (hands, fingers, feet,
etc.) are positioned directly under
the mowing deck.
After detaching the mowing deck,
the mowing deck mounting
automatically swings upwards.
To Next Page
Loading...
