Stihl RT 4097 SX - Mowing Deck Installation

ENNO
31
SVFIDAPL
0478 192 9810 A - EN
mowing deck mounting (3).
Insert the cotter pin (5) through the bore in
the mounting pin.
● Repeat this procedure on the other
side.
Attaching the mowing deck at the rear:
● Raise mowing deck at the rear with one
hand and hold. The bore of the rear
mowing deck mounting must be aligned
with the mounting pin on the mowing
deck.
Insert the mounting pin on the mowing
deck (1) into the bore on the rear mowing
deck mounting (4).
Insert the cotter pin (5) through the bore in
the mounting pin.
● Repeat this procedure on the other
side.
Fitting the V-belt:
Press the retaining plate (7) forwards and
hold in place. Pull the V-belt (10) forwards
and lift with the V-belt cover (6).
Fit the V-belt (10) correctly onto the V-belt
pulley (without twisting).
Installing the front V-belt cover:
Press the retaining plate (7) forwards and
hold in place. Fold the V-belt cover (6)
upwards. Guide the retaining plate (7) to
the rear and engage at the two retaining
tabs on the V-belt cover (6).
Fasten the retaining plate in place by
screwing in the screw (8). Tighten the
screw (8).
Tensioning the V-belt:
● Select the lowest cutting level. (Ö 8.13)
Note
Before attaching, check that the
mowing deck is correctly attached
at the front mowing deck mounting.
Risk of injury:
In the lowest cutting level, the
cutting height adjustment lever is
under tension. Do not touch the
cutting height adjustment lever
during installation of the mowing
deck.
Fit the V-belt onto V-belt pulley
without twisting.