0478 192 9810 A - EN
38
Front axle: A> 230mm
Rear axle: B > 210 mm
Removing the wheel:
Detach cap (1).
Remove retaining ring (2) using a
screwdriver.
Remove large washer (3) and small
washer (4) (only fitted on rear wheel).
Remove wheel (5) from the axle.
Installing the wheel:
The following points must be observed
before installing the wheels:
● Remove dirt from the wheel axle.
● Lightly coat the wheel axle with grease
before installation.
Rear wheels:
Insert the feather key (6) in the rear wheel
axle. Fit the wheel (5) – valve located on
outside – over the feather key and push
onto the wheel axle to the stop.
Push the small washer (4) and the large
washer (3) onto the wheel axle.
Front wheels:
Fit the wheel (5) – valve located on outside
– onto the wheel axle to the stop.
Push the large washer (3) onto the wheel
axle.
When removing the rear wheels,
ensure that the couplers (feather
keys) are not lost.
Before installing the rear wheels,
ensure that the couplers (feather
keys) are located in the grooves of
the wheel axle on both sides.
When mounting the wheels, ensure
that the valves are always located
on the outside.
To Next Page
Loading...
