SG 51, SG 71
English
12
Before filling the tank with chemicals,
carry out a test with fresh water and
check all parts of the sprayer for leaks.
N Stand the sprayer on a level
surface.
N Remove the cap from the tank.
N Check the O-ring (1) in the cap (2).
It must be in good condition.
N Fill up with thoroughly mixed plant
protection solution – do not overfill
(no further than max. mark – arrow).
N Fit the cap and tighten it down firmly
with both hands.
N Carry the unit on your back with
both harness straps – do not hang it
over one shoulder.
N Operate the pump lever slowly and
steadily with the gun closed –
several strokes are required to build
up pressure.
N Operate the gun and always pay
attention to the optimal working
pressure while spraying.
N If the working pressure drops,
restore it by operating the pump
handle.
Filling the Container
max
8014BA013 AS 8014BA012 AS
1
2
max
8014BA011 AS
Spraying
To Next Page
Loading...
