EasyManua.ls Logo

Stihl SH 56 C-E - Post-Start Engine Procedures; Engine Stopping Procedure; Troubleshooting Engine Start Issues; Checks for Starting Failure

Stihl SH 56 C-E
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BG 56, BG 56 C, BG 66, BG 66 C, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
English
13
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
As soon as the engine runs
N Blip the throttle trigger (3) – the
choke knob moves to the run
position F – the engine returns to
idle speed.
Stopping the Engine
BG 56, BG 66, SH 56
N Move the stop switch to 0 – the
engine stops – the stop switch
springs back to the on position.
BG 86, SH 86
N Move the setting lever to 0 – the
engine stops – the setting lever
springs back to the on position.
Other hints on starting
If the engine stops while the choke
knob in on g or during acceleration
N Move the choke knob to < and
continue cranking until the engine
runs.
If the engine does not start
N Make sure all settings are correct
(choke knob, setting lever in run
position F).
N Repeat the starting procedure.
If fuel tank has been run completely
dry and then refueled
N Press the fuel pump bulb (1) at least
five times – even if the bulb is filled
with fuel.
N Now start the engine.
296BA008 KN
3
296BA008 KN
295BA072 KN
295BA073 KN
1
296BA009 KN

Related product manuals