[SNR_Complete]
4
English
5 Installing the Battery
Mounting and Operation
WARNING
￭ Before mounting, read and follow all warnings and safety
instructions provided with the power equipment.
– Before mounting, read and follow all warnings and
safety instructions provided with the power
equipment.
￭ Use common sense when mounting to reduce the risk of
personal injury or property damage.
￭ Never mount the Smart Connector on product handles,
switches, controls, cooling inlets, guards or moving parts.
￭ Ensure that no electrical parts, cables, fuel lines or other
components will be damaged if drilling holes or using
screws to install the STIHL Connector.
￭ Never cover safety warning labels or other on-product
markings.
￭ Never mount the Smart Connector in a manner or in a
location that interferes with proper working technique or
your ability to control the power tool.
￭ Never mount in areas on the tool that are exposed to heat
or sparks.
Maintenance and Storage
WARNING
￭ Reduce the risk of short circuit:
– Keep the Smart Connector free of foreign matter
– Clean with a dry cloth or soft, dry brush.
– Never clean with detergents or solvents, which may
damage the polymer housing.
– Never spray with a pressure washer or otherwise
spray with water or other liquids.
￭ Improper storage can lead to unauthorized use, damage
to the Smart Connector and power tool it’s connected to,
and increase the risk of personal injury and property
damage.
– Reduce the risk of unauthorized use.
– Store the Smart Connector in a dry, secure place out
of the reach of children and other unauthorized
users.
The STIHL Connector is powered by a CR2032 button-cell
battery. Never attempt to use any other type of battery.
To install the battery in the Smart Connector:
► Using a coin or flat head screwdriver, turn the Smart
Connector cover (1) counter-clockwise to the unlocked
position (2).
► Remove the cover.
► Remove and discard the protective battery foil (4).
► Install the battery according to the polarity markings (+/-)
on the Smart Connector battery compartment.
► Replace the cover. The LED (x) will glow green for three
seconds when the battery is properly inserted.
► Turn the cover clockwise to the locked position (x).
5 Installing the Battery
To Next Page
Loading...
