SR 430, SR 450
English
31
If strainer is dirty:
N Insert a suitable tool (e.g.
screwdriver) in the two recesses
(arrows) to loosen the strainer (1).
N Pull the strainer (1) upward and out
of the solution container.
N Clean the strainer (2) with clear
water and a brush.
After dusting and spreading – SR 450
only
N Run the unit until the solution
container is completely empty
N Close the metering lever.
N Shut off the engine – see "Starting /
Stopping the Engine".
N Rinse and clean the solution
container with clear water.
N Dispose of any residual rinsing
solution in accordance with
environmental requirements –
follow instructions of the chemical
manufacturer.
N Allow the machine to dry with the
cap removed.
N Store the machine in a dry, high or
locked location sheltered from frost
– out of the reach of children and
other unauthorized persons.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Do not expose the container to
direct sunlight for unnecessarily
long periods. UV rays can make the
container material brittle, which
could result in leaks or breakage.
Storing the Machine
To Next Page
Loading...
