04-015
1
04-015
14” CUT-OFF SAW
Gas Powered Stihl 700
PROCEDURES:
• Unit will be sent with 50:1 gas mixture, wrench and goggles.
• Use only in well ventilated areas. Gas fumes are hazardous!
• Area must be clear of any debris before cutting.
• Determine what type of material is to be cut. Asphalt, concrete, metal and ductile blades are
available. 6300 rpm or faster are required.
• Blades must have a 20mm arbor.
• SHUTDOWN: Allow engine to idle down approximately 5 minutes to reduce engine heat
from burning protective coating of oil in cylinder.
• Customer should clean air filter after every four hours of usage.
• Customer will be instructed on proper filter and gasket combination. Exploded view diagram
provided on back of page.
• Consult owner’s manual for changing position of blade.
• Customer will be charged for any clean up or damage due to neglect.
To Next Page
