What to do if my Stihl MSA 220 T cuts out during operation?
If your Stihl Saw cuts out while you're using it, it could be due to the chainsaw overheating. Engage the chain brake, remove the battery, and allow the chainsaw to cool down. Another cause might be an electrical fault; engage the chain brake, remove and refit the battery, and switch the saw back on.
Why does my Stihl Saw chain oil LED light up in red?
The SAW CHAIN OIL LED on your Stihl Saw might light up red due to several reasons. It could indicate insufficient saw chain oil in the oil tank, so top it up. Alternatively, the saw chain lubrication system might not be supplying enough oil; in this case, increase the oil feed rate. The saw chain may also be over-tensioned, so tension it correctly as specified. Lastly, improper chainsaw usage can trigger this warning; seek proper instruction and practice.
What to do if Stihl MSA 220 T chain oil LED flashes red?
If the SAW CHAIN OIL LED on your Stihl Saw flashes red, it indicates that the saw chain oil sensor is defective. Do not use the chainsaw and consult a STIHL dealer.
How to fix smell of smoke or burning in the cutting area of Stihl Saw?
If you notice a smell of smoke or burning in the cutting area of your Stihl Saw, it's likely that the saw chain hasn't been sharpened correctly. Sharpen the chain as specified.
Why is the run time of my Stihl chainsaw too short?
If you're experiencing a short run time with your Stihl chainsaw, the battery might not be fully charged. Recharge the battery completely. Also, the battery life could be exceeded, meaning it's time to replace the battery.
General| Power Source | Battery |
|---|---|
| Weight (without battery) | 5.3 lbs (2.4 kg) |
| Battery Voltage | 36 V |
| Recommended Battery | AP 300 S |
| Rated Voltage | 36 V |
| Type | Chainsaw |
| Bar Length | 35 cm |
| STIHL Oilomatic saw chain type | PM3 |
| Chain gauge | 0.043" (1.1 mm) |
| Chain Pitch | 3/8 in. |
Detailed diagram and description of chainsaw and battery components.
Meanings of warning symbols displayed on the chainsaw and battery.
Requirements and conditions for the safe operation of the chainsaw by the user.
Specifies essential safety clothing and personal protective equipment (PPE).
Safety guidelines for the work area and surroundings when using the chainsaw.
Criteria for ensuring the chainsaw is in a safe operating condition.
Details on maintaining the chainsaw in a safe and operational state.
Conditions for the battery to be considered safe for use.
General guidelines for working with the chainsaw.
Specific techniques and precautions for sawing operations.
Explanation of reactive forces like kickback, pull-in, and pushback.
Causes and prevention of kickback when operating the chainsaw.
Description of the pull-in reaction and how to handle it.
Description of the pushback reaction and how to handle it.
General guidance on cleaning, maintenance, and repair procedures.
Detailed checklist for preparing the saw for safe and effective operation.
Procedures for attaching and detaching the guide bar and saw chain.
Detailed instructions for mounting the guide bar and saw chain.
Method for adjusting the tension of the saw chain for optimal performance.
Steps to engage the chain brake for safety.
Steps to disengage the chain brake before operation.
Step-by-step guide to properly insert the battery.
Step-by-step guide to safely remove the battery.
How to safely start the chainsaw.
How to safely stop the chainsaw.
Basic information and safety for felling trees.
A table listing faults, causes, and remedies for the chainsaw.
To Next Page
