TS 700, TS 800
English
28
Removing the V-belt guard
N Pull the V-belt guard (1) off and
remove the V-belt (2) from the front
pulley (3)
N Remove the "support and guard" (4)
Preparing the "support with guard" for
outboard mounting
N Unscrew the stop pin (1)
N Remove the sealing plug (2)
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin (1)
N Insert the sealing plug (2)
N Move the adjusting lever (3) to
position A
N Insert and tighten the screw (4)
N Turn the "support with guard" so
that the guard is on the outboard
side
N Insert the square nut into the guide
in the guard and hold it in place
N Screw in the shorter banjo bolt (5)
and washer at the adjusting lever
and tighten up with the combination
wrench
N Insert the sealing plug (2)
N Insert and tighten the screw (4)
Mounting "support with guard" – guard
on the outboard side
N Fit the "support with guard" (1) on
the outboard side of the cast arm -
at the same time, guide the V-belt
over the belt pulley
NOTICE
The belt action must run smoothly.
N Position the V-belt guard (2)
N Align studs (3) in support with
nuts (4) in the V-belt guard
N Screw nuts (4) onto studs (3) – do
not tighten them yet
To Next Page
Loading...
