TS 700, TS 800
English
27
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the V-belt”.
Outboard mounting (TS 800)
N Disassemble the abrasive wheel
(see “Fitting / replacing an abrasive
wheel”)
Removing the water attachment
N Unscrew the banjo bolt (1) with the
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
N Remove the water hose (2) with
connector from the adjusting
lever (3)
N Unscrew the screw (4)
Removing the adjusting lever
N Unscrew the banjo bolt (1) with the
combination wrench and remove it
together with the seal – in the
process, remove the square nut
from the inside of the guard from the
guide
N Unscrew the screw (2)
N Turn the adjusting lever (3) upwards
and remove
N Remove the sealing plug (4)
Slackening the V-belt
N To relax the poly V-belt, loosen the
nuts (1) – do not unscrew the
nuts (1) from the studs
N Turn the tensioning nut (2)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N Unscrew nuts (1) from the studs –
nuts (1) are fastened to the belt
guard so that they are secured
against loss
To Next Page
Loading...
