TS 700, TS 800
English
30
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the V-belt”.
This machine is equipped with an
automatic spring-action V-belt
tensioning device.
Prior to tensioning of the ribbed V-belt,
the nuts (1) must be loosened and the
arrow on the tensioning nut (2) must
point to 0.
N otherwise loosen the nuts (1) and
the tensioning nut (2) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
N to tighten the ribbed V-belt, fit the
combination wrench over the
tensioning nut as illustrated
WARNING
The tensioning nut is spring-loaded –
hold the combination wrench securely.
N Turn the tensioning nut clockwise
approx. 1/8 turn – the tensioning
nut will be engaged by the spring
N Continue turning approx. 1/8 turn –
up to the stop
NOTICE
Do not turn the combination wrench
further by force.
The V-belt is automatically tensioned by
the force of the spring in this position.
N Remove the combination wrench
from the tensioning nut
N Tighten nuts (1) on the V-belt guard
Retensioning the V-belt
The V-belt is retensioned without the aid
of the tensioning nut.
N Unscrew the three nuts on the V-
belt guard
The V-belt is automatically tensioned by
the force of the spring.
N Retighten the nuts
Tensioning the ribbed V-belt
To Next Page
Loading...
