TS 700, TS 800
English
31
The engine must be switched off for
fitting or replacement – set Master
Control lever to STOP or 0.
Blocking the shaft
N Slide the locking pin (1) through the
bore in the V-belt guard
N Turn the shaft with the combination
wrench until the locking pin (1)
engages in a bore behind the guard
Removing an abrasive wheel
N Use the combination wrench to
loosen and remove the hexagon
head screw (2)
N Remove the front thrust washer (3)
from the shaft together with the
abrasive wheel
Fitting an abrasive wheel
N Fit the new abrasive wheel (4)
WARNING
Note the arrows indicating the direction
of rotation on diamond abrasive wheels.
N Fit the front thrust washer (3). The
catches of the front thrust
washer (3) must engage in the shaft
grooves.
N Screw in the hexagon bolt and
tighten it with the combination
wrench – if using a torque wrench,
refer to the "Specifications" for the
tightening torque
N Draw the locking pin out of the V-
belt guard
Fitting / replacing an abrasive
wheel
1
377BA028 KN
To Next Page
Loading...
