TS 700, TS 800
English
48
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Engine
STIHL single cylinder two-cycle engine
TS 700
TS 800
Ignition system
Electronic magneto ignition
Fuel system
All position diaphragm carburetor with
integral fuel pump
Air filter
Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Abrasive wheels (TS 700)
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 6.0 cu. in. (98.5
cm
3)
Cylinder bore: 2.2 in. (56 mm)
Piston stroke: 1.57 in. (40 mm)
Engine power accord-
ing to ISO 7293:
6.7 hp (5.0 kW)
at 9300 rpm
Idle speed: 2200 rpm
Max. spindle speed: 5350 rpm
Displacement: 6.0 cu. in. (98.5
cm
3)
Cylinder bore: 2.2 in. (56 mm)
Piston stroke: 1.57 in. (40 mm)
Engine power accord-
ing to ISO 7293:
6.7 hp (5.0 kW)
at 9300 rpm
Idle speed: 2200 rpm
Max. spindle speed: 4600 rpm
Spark plug
(suppressed):
Bosch WSR 6 F,
NGK BPMR 7 A
Electrode gap: 0.02 in. (0.5 mm)
Fuel tank capacity: 40.6 oz
(1.2 l)
without fuel, without abrasive wheel,
with water attachment
TS 700: 25.6 lbs.
(11.6 kg)
TS 800: 28.0 lbs
(12.7 kg)
Outside diameter: 14 in.
(350 mm)
Bore diameter/spindle
diameter:
0.787 in.
(20 mm)
Tightening torque: 22 lbf ft
(30 Nm)
Composite resin abrasive wheels
Minimum outside diameter of
front thrust washer:
4.06 in.
(103 mm)
Max. depth of cut: 4.9 in.
(125 mm)
To Next Page
Loading...
