STINGRAY READY
FOR USE
* Remove the Stingray from the box.
* Pull up (A) to lift the backend of the frame.
Make sure the frame clicks into place.
* Lift the push brace upwards until it clicks (B).
* Lock the handles (C).
Make sure that the red security handle (D)
on the back is tipped up. If the red handle
is pushed down, the seat is not installed
correctly on the interface.
* Mount the seat on the interface by sliding the
seat into the interface until it clicks. Pull the
seat outwards to make sure that it has clicked
into position.
* Push down the red security handle (D) when
the seat is mounted.
Follow the instructions on the next pages, to
position the back, seat and footplate.
Stingray is now ready for use.
GB
To Next Page
Loading...